Rubber Pad

crane hoist manufacturer

Gantrail resilient crane rail pads are designed to allow the rail to move and rotate by small amounts. When rails are on a pad—called soft mounting—this helps to ensure a more even stress distribution between the crane wheel and rail, as well as between the rail and the surface on which it is fixed. Gantrail sell two pad types for continuously supported rail and discontinuous mounting.
 

Resilient Crane Rail Pads

Gantrail Mark II elastomer pad is used under rails that are discontinuously supported.

Gantrail Mark VII steel reinforced continuous pad is used under rails which are continuously supported.

A ‘soft mounted’ rail has many distinct advantages, not least a reduction in noise levels and vibration. Moreover, the resilient pad compensates for any uneven surfaces in the rail or steel support and thereby distributes the wheel load over a larger area. This reduces load concentration and fatigue in the support structure. The Mark VII pad has a grooved surface that results in a non-linear load deflection characteristic thereby controlling rail bending stresses.

A further advantage is the prevention of fretting corrosion between the rail and the supporting nominal steelwork. The standard resilient pad is 7 mm thick and is normally supplied in widths less than the rail base width.

The pad is positioned between the rail and sole plate Gantrail crane rail pads
Mark VII Gantrail Pad showing steel and rubber encapsulation

 

 

Crane Rail Pads

The Gantrail pad can be supplied for any crane or railway rail. It is supplied at just under the width of the foot of the rail so that the adjustable Gantrail clips can fit tightly to the foot of the rail.

Mark II Pad Section
Mark II Pad Section


Mark VII Pad Section

A pad can reduce the stress on the crane runway beam or girder by a significant amount.

Using a pad reduces the risk of fatigue failure in the support structure.

A pad can allow the rail to rotate by small amounts and this means that the crane wheel can force the rail into a position where there is good contact across the whole width of the head of the rail.

crane rail pads in steelworks
In steelworks, the pad offers oil resistance and reduces fatigue in girders

Pad eliminates the metal to metal contact between the steel rails and steel support. Thus it substantially reduces the wear, fretting and corrosion between the rail and the support. This is particularly valuable in outdoor applications or places where oil, grease and moisture are to be found.

The elastomer Mark II pad and the steel reinforced Mark VII pad have been tested and are approximately five times stronger in compression than is needed for the highest crane wheel load.